E3D PT100 Temperature Sensor

$ 14.98

Make your HotEnd run at higher temperatures with better accuracy and easier assembly with a PT100 sensor using this amplifier board.

PT100's are high temperature, high accuracy temperature sensors that you can now use on your E3D V6 HotEnd instead of a thermistor or thermocouple. PT100's are able to measure higher temperatures than thermistors - upto 400°C, and are more accurate then both thermistors and thermocouples in general. Our PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fiberglass sleeving or clamping washer.

The PT100 sensor will fit in the e3d cartridge style heater blocks

Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.

The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your E3D Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2.

Why buy from FilamentOne

  • USA company manufacturing and distributing 3D printing supplies and tools
  • Years of experience in the plastic industry and 3D printing technologies
  • Known for premium quality 3D printing filaments, great customer service and as a valued member of the community

 

Customer Reviews

No reviews yet Write a review

You recently viewed

Clear recently viewed