MKS-Gen V1.4 Controller Board Integrated Ramps 1.4 and Mega 2560

$ 32.00
MKS Gen is a feature rich all-in-one electronics solution for Reprap and other CNC devices.

It features an onboard ATmega2560. Its five motor outputs are powered by Pololu pin compatible stepper drivers.

The board features a developer friendly expansion port supporting giving access the same as Ramps1.4.

MKS Gen is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V.
  • Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
  • Firmware can use the same configuration as ramps1.4
  • Easy DISPLAY + SD-CARD connector,RepRapDiscount SmartController compatible pin header on board
  • All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1)
  • 3x temperature ADC connectors for thermistors
  • up to 5 motor driver with easy micro stepping setup (micro switches)
  • 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
  • 4 layers PCB, optimize heat dissipation.
  • 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
  • 3* 5V output, 3* 12V-24V output interface.
  • Recoverable fuse for short-circuit protection.

You recently viewed

Clear recently viewed